Cover of The Hydroelectric Dam: Water, Concrete, Power, a book by Ketineni RamaraoFrom the book The Hydroelectric Dam: Water, Concrete, Power
Chapters 1, 9-12 and 18. Read the full book free as a PDF.

Start with height, not the wall

A reservoir looks like stored water. For a power station, it is also stored gravitational energy. Water at the reservoir surface is higher than the water leaving the powerhouse. Engineers call the usable difference in elevation the head. The US Department of Energy identifies head and water flow as the central limits on hydroelectric output.

A photograph of a large wall therefore tells you little about generation. A high drop with a modest stream and a low drop with a broad river can both support a power station. They require different waterways and turbines. The wall is part of the arrangement, not the source of the energy. The water cycle replenishes the supply, while the landscape provides the drop.

Follow the water through the station

Water enters an intake and travels toward the turbine through a waterway, often a closed pipe called a penstock. Gates and valves regulate its path. The water turns the turbine runner; a rotating shaft drives a generator. After giving up part of its energy, water returns downstream.

Reservoir: elevation; Penstock: water flow; Turbine: rotation; Generator: electricity; Tailrace: river return
Original IOI explanatory diagram, based on the linked sources; not to scale.

The turbine and generator have separate jobs. The turbine extracts mechanical work from water. The generator converts the rotating shaft's work into electricity. Calling the whole assembly a generator is convenient, but it hides the two different engineering problems: handling water without wasting too much energy, and converting rotation into electrical output.

Flow matters as much as head

Head gives each quantity of water its potential to do work. Flow determines how much passes through the machine over time. Increase one while holding the other steady and the available hydraulic power rises. Reduce either and it falls. A turbine cannot compensate indefinitely for a dry river merely by turning faster.

Actual electrical output is below the available hydraulic power because the waterway and machines have losses. A station's advertised generating capacity is consequently not a promise of continuous output. A nameplate describes a capability under specified operating conditions, not a guarantee of water. The river remains part of the power station even when it is outside the fence.

Water has other instructions

An impoundment plant stores water behind a dam, but generation is not the only reason to release it. DOE lists flood control, recreation, fish passage and water quality among considerations shaping reservoir operation. The most profitable generating schedule is not necessarily the only permissible schedule.

Not every visible discharge therefore represents wasted electricity. Water management and energy conversion overlap, but they are different responsibilities. Managing a river safely is not the same task as extracting energy through a particular set of machines. A reservoir may serve users who have no interest in when the generator starts.

Storage changes timing, not the physics

Water held now can be released later, within reservoir conditions and operating limits. A diversion or run-of-river plant instead uses a canal or penstock to exploit the riverbed's natural decline, sometimes without a dam. Both arrangements can turn a turbine and generator through the same basic conversion chain.

The difference lies upstream of the machine. One installation has a store whose level and permitted releases matter; another depends more directly on incoming flow. Neither escapes the relationship between head and flow. Storage creates options over time, not an unlimited new water supply.

Read the system as a route

The useful questions are concrete. Where is the head? How does water reach the runner? Which machine suits the head and flow? Where does the water return? What other demands govern releases? Those questions explain more than the height of the concrete face alone.

The Hydroelectric Dam follows that route from falling water to machine hall and grid. The diagram here describes a mechanism, not any named project. Actual stations arrange intakes, waterways and powerhouses differently. What connects them is the same chain: elevated water becomes controlled motion, motion becomes shaft work, and shaft work becomes electricity.

Quick answers

Does every dam generate electricity?

No. Dams can serve water supply, irrigation, flood control and other purposes without a power station.

What is head?

The difference in elevation available to drive water through the hydroelectric system.

Sources

Technical claims checked against the sources below; no current market-size or price claim is made.

More from this book

Machines · From the book The Hydroelectric Dam: Water, Concrete, Power

Pelton, Francis or Kaplan: why hydro turbines differ

There is no single best hydro turbine.

Plant design · From the book The Hydroelectric Dam: Water, Concrete, Power

Reservoir or run-of-river: what storage changes

One plant holds water for later.

Storage · From the book The Hydroelectric Dam: Water, Concrete, Power

How pumped storage turns two reservoirs into a battery

The uphill journey consumes electricity.

Environment · From the book The Hydroelectric Dam: Water, Concrete, Power

What a hydroelectric dam changes in a river

Water leaves a turbine without becoming ash or exhaust.