History · Communication Services · Diversified Telecommunication Services
The history of submarine cables, from telegraph to fibre
Submarine cables have been rebuilt around their failures. The Channel cable showed that armour was needed. The 1858 Atlantic cable showed that signalling mattered as much as the wire. Fibre replaced copper when copper ran out of room.
From the book The Submarine CableChapters 6 to 11, 18 to 22. Read the full book free as a PDF.
Short cables become routine
After the success of the first cables in the early 1850s, Atlantic-Cable.com says, laying short cables became routine, while long ones presented more problems. It was of considerable financial and political interest to span the Atlantic, and the attempts in 1857, 1858 and 1865, and the eventual success in 1866, attracted much attention.

1858: a very expensive trial run
The 1858 cable was laid by the warships Niagara and Agamemnon. It was made of seven copper strands insulated with three layers of gutta-percha, and PBS records about 300 tons of gutta-percha used on the first 2,500 nautical miles of cable. It worked, to tumultuous rejoicings on both sides of the Atlantic, but in its 23 days of operation it carried only 732 messages, according to the University of Glasgow. The company's electrician insisted on using his own instrument in place of William Thomson's sensitive mirror galvanometer, and burned the cable out with several thousand volts. A paper on Heart's Content describes the 1858 cable as "a very expensive trial run" and says the promoters had no notion that there might be electrical difficulties. Part of the damage was also physical: the cable had lain in the sun on a wharf for the better part of a year.
1866: the lasting Atlantic cable
On 13 July 1866 the Great Eastern, by far the largest ship afloat, left Valentia in Ireland with 2,730 nautical miles of cable in her hold. Fourteen days later 1,852 miles of it lay on the bottom, and she was at anchor in Trinity Bay, Newfoundland. The ship then went back out, grappled for and raised the end of the cable abandoned the year before, and spliced a new section onto it. On 6 September there were two working lines between Valentia and Heart's Content. The design was not much different from the 1858 cable: a stranded copper core, gutta-percha, a jute cushion and iron wires, with heavier wires near shore. The difference was care in manufacture and testing, and a better receiver. Thomson's mirror galvanometer was used exclusively in 1866, and a good team could read about eight words a minute. One man watched the dancing spot of light and read off the dots and dashes while a second wrote them down. The instrument gave no record, so a message could not be checked afterwards.

Voice: TAT-1 in 1956
Telegraph cables carried signals, not speech. TAT-1 changed that. On 25 September 1956 the first telephone call across the Atlantic by submarine cable was made between London, New York and Ottawa. TAT-1 had two coaxial cables with unidirectional valve amplifiers designed by Bell Labs. These repeaters were housed in flexible units that could pass through existing cable-laying machinery, and the system gave 36 voice circuits of 4 kHz. British engineers developed a rigid repeater housing that was carried past the cable machinery on a trolley with a bypass rope, and later tested parachutes attached to repeaters to relieve strain on the cable as they sank.
Light: TAT-8 in 1988
TAT-8 was the first fibre-optic cable to cross an ocean, and entered service on 14 December 1988, according to the Engineering and Technology History Wiki. It was built by a consortium led by AT&T, British Telecom and France Telecom. Nokia Bell Labs reports that its design life was 25 years, with an objective of no more than three ship repairs from failures in the system's own parts. That 25 year design life has been conventional since.
The cable now
The International Cable Protection Committee counted about 500 cable systems and around 1.8 million kilometres of cable in May 2026. For the physical layout, see how undersea internet cables work. For the first step in this history, see the first submarine cable.
Quick answers
When was the first transatlantic telegraph cable laid?
In 1858. It worked for about 23 days and carried 732 messages before it failed. The first lasting Atlantic cables were laid in 1866 by the Great Eastern.
What was TAT-1?
The first transatlantic telephone cable, opened on 25 September 1956. It used two coaxial cables with Bell Labs repeaters and gave 36 voice circuits.
What was TAT-8?
The first transatlantic fibre-optic cable. It entered service on 14 December 1988 and was designed to last 25 years.
Sources
- Atlantic-Cable.com, "Atlantic Cables: 1857-58, 1865-66" index
- PBS American Experience, "Gutta-percha"
- University of Glasgow Library, Kelvin and the Atlantic cable
- Atlantic-Cable.com, "Heart's Content" (growing cable stations, 1870s)
- Atlantic-Cable.com, "Coaxial Commonwealth Cables" (TAT-1 and successors)
- ETHW, "Milestones: Trans-Atlantic Telephone Fiber-Optic Submarine Cable (TAT-8), 1988"
- Nokia Bell Labs, "TAT-8: The First Transatlantic Optical System"
- International Cable Protection Committee, "Media Enquiries & Frequently Asked Questions"
