Cover of The Submarine Cable, a book by Ketineni RamaraoFrom the book The Submarine Cable
Chapters 25, 31 and 33. Read the full book free as a PDF.

How often

The International Cable Protection Committee says approximately 150 to 200 submarine cable faults occur globally each year. Around 70 to 80 per cent are caused by accidental human activity, such as commercial fishing and ships' anchors, rather than sabotage. The ITU, citing the ICPC, puts this at about three cable repairs a week, and lists accidental human activity alongside natural hazards, abrasion and equipment failure.

Anchors

The ICPC says damage from dragged anchors accounts for about 30 per cent of incidents each year, around 60 faults. Anchors can drag after being deployed on purpose, or deploy by accident from a mechanical failure while a ship is under way. One event can cut several cables and create a backlog for repair ships. Telecommunications repairs average £500,000 to £1 million per incident, the ICPC reports, and power cable repairs cost far more.

Fishing

The ICPC's fishing publication calls bottom trawls, beam trawls and dredges the number one cause of faults on a global scale. The picture is more nuanced than "trawlers cut cables". The ICPC says trawl gear usually penetrates 5 to 20 cm into the seabed, locally 50 cm or more in very soft sediment, and that more than 90 per cent of trawl crossings of a cable do not damage it. Many modern cables are buried more than 60 cm deep to depths of 1,000 metres, which reduces fault rates.

Why deep water is not safe

Cables are harder to bury in deeper water, and deep cable carries less or no armour. Fishing gear in deeper water is heavier, and fishers drag grapnels to recover gear fixed in place. The ICPC reports growth in faults from static gear in 500 to 1,800 metres, and sometimes almost 5,000 metres, including Fish Aggregating Devices whose mooring lines can abrade the cable sheath and cause a short circuit known as a shunt fault.

A black and white engraving of a large ship's bow towering over a small rowing boat, with men in the boat reaching toward a rope in the water.
A repair under way: the cable ship Electra grappling for a cable, from The Graphic, 28 July 1894. Hooked iron on a rope still finds cables on the seabed. Photo: D. B. Waters (The Graphic), Public domain, via Wikimedia Commons.

How a repair works

A fault is found with tests from the shore end. A cable ship is sent to the site, and the cable is cut and lifted to the surface with an ROV or a grapnel, the same hooked iron fishermen use to recover lost gear. The damaged section is replaced and spliced, and the cable is lowered back to the seabed. The extra length of cable needed where the cable reaches from the bottom to the ship is at least twice the water depth, and it is laid as a loop on the seabed. This is why repair needs ship time and permits, and why the ICPC advocates timely repair permitting. Cable ships are kept on standby.

Resilience, not immunity

The ICPC says networks are designed with redundancy so traffic can be rerouted over other cables and land routes. The ICPC describes risks in the Strait of Hormuz as regional rather than global for this reason. For how cables are buried to avoid this, see how undersea cables are laid. For the first lessons in armour, see the first submarine cable.

Quick answers

How often do undersea cables break?

The ICPC says about 150 to 200 faults occur each year worldwide, which the ITU puts at about three repairs a week.

What causes most undersea cable breaks?

Accidental human activity: fishing and ships' anchors cause around 70 to 80 per cent of faults, according to the ICPC. Dragged anchors account for about 30 per cent.

How are undersea cables repaired?

A cable ship lifts the cable with a grapnel or ROV, cuts out the damaged section, splices in a replacement and lowers it back to the seabed.

Sources

Fault frequency and cause shares are from the ICPC enquiries page and the ITU; the anchor share and repair costs are from ICPC dragged-anchor paper. Trawl penetration, crossing outcomes and deep-water fishing risks are from the ICPC March 2021 environment paper. The repair method and the "twice the depth" rule are from the ICPC fishing booklet (2009).

More from this book

History · From the book The Submarine Cable

The first submarine cable: Dover to Calais, 1850

The first international submarine cable was a bare copper wire coated in tree sap.

History · From the book The Submarine Cable

The history of submarine cables, from telegraph to fibre

Submarine cables have been rebuilt around their failures.

Explainer · From the book The Submarine Cable

How undersea internet cables work

An ocean cable looks like a garden hose and does the work of a continent's wiring.

Explainer · From the book The Submarine Cable

How undersea cables are laid

Laying an undersea cable starts years before the ship sails.