Cover of The Steam Turbine: Heat, Spin, Current, a book by Ketineni RamaraoFrom the book The Steam Turbine: Heat, Spin, Current
Chapters 9, 11 and 15. Read the full book free as a PDF.

What the 2024 data says

Ember's Global Electricity Review 2025 reports the world's generation mix for 2024. Coal provided 34.4% of global electricity and gas 22%, with other fossil fuels at 2.8%. Nuclear provided 9.0%. Hydropower provided 14.3%, wind 8.1% and solar 6.9%. Other renewables, such as bioenergy and geothermal power, provided 2.6%. Low-carbon sources together passed 40% of global electricity for the first time since the 1940s, at 40.9%.

Coal and nuclear plants are designed around a boiler or reactor, a steam turbine and a generator. Adding the two published shares gives 43.4% of world electricity in 2024 (34.4% plus 9.0%). That sum is the share from two source types that use steam-cycle plants. It is not a measured count of steam-turbine output, because Ember reports generation by fuel, not by the machine that turns the generator.

What this number leaves out

The 43.4% is a boundary, not a total. It excludes several other steam-turbine uses: the steam half of gas combined-cycle plants, steam plants burning bioenergy, geothermal steam plants and concentrated solar thermal plants. The Ember page used here does not say how much of the gas, bioenergy or geothermal share goes through steam turbines, and it does not map coal and nuclear generation to turbine units either. So the honest statement is narrow: coal and nuclear, which are built around steam turbines, supplied 43.4% of the world's electricity in 2024, and the full steam-turbine share is a different number that these sources cannot give. Anyone quoting a single percentage should show where they drew the line.

Looking up at three rows of long, tapering steel turbine blades arranged in discs against a clear blue sky.
Rows of low-pressure turbine blades from the Philippsburg nuclear power plant, Germany, now on display at the Technik Museum Speyer (2004). The blades grow longer toward the exhaust because steam expands as it loses pressure. Photo: AlfvanBeem, CC0, via Wikimedia Commons.

The scale of one machine

The largest steam turbines are for nuclear plants. Arabelle Solutions describes its Arabelle as the most powerful nuclear steam turbine in operation, suitable for reactors from 700 to 1,900 MW, with more than 50 units delivered or on order, and a 75-inch last-stage blade. It quotes 99.96% reliability and a 0.04% forced outage rate over ten years. These are manufacturer claims, but they show the scale: 1,900 MW from one machine.

The reason these machines are so large is economic. A steam cycle gains efficiency with scale and with higher steam temperature and pressure, so the industry built bigger units and hotter boilers for a century. Supercritical plants run above 22 MPa and 374 C. The company data cited in the references shows combined-cycle efficiencies of about 64% at the highest gas turbine temperatures, Parts of that comparison come from a general reference citing manufacturer charts, so check the current figures before quoting them.

The materialist reading

Electricity looks like a weightless service, but a large part of it still comes from heating water and spinning a heavy steel rotor. For coal and nuclear plants, which supplied 43.4% of the world's electricity in 2024, the conversion step is the same kind of machine. That is why the steam turbine matters even as solar and wind grow: the share of coal and nuclear may fall, but together they still supply a large fraction today, and the world's installed turbines will need parts and repair for decades. The engineering of that machine is in how a steam turbine works, and who builds and maintains the fleet is in who makes steam turbines.

What changed in 2024 was the mix, not the machine. Clean electricity rose to 40.9% and fossil fuels fell to 59.1%, below 60% for the first time since the 1940s, but fossil generation still rose by 1.4% in absolute terms. Nuclear's share fell to a 45-year low even as its output grew by 69 TWh.

Limits: these are 2024 shares for the whole world and say nothing about any country. The 43.4% figure is the sum of two published shares, added here. Output from other steam-turbine plants is excluded and not quantified.

Quick answers

What share of electricity comes from steam turbines?

No source reviewed gives one figure. Coal (34.4%) and nuclear (9.0%) plants, which are built around steam turbines, together supplied 43.4% of world electricity in 2024. That is a partial count: steam turbines are also used in gas combined-cycle, biomass, geothermal and solar thermal plants, and these sources do not quantify them.

Do wind and solar use steam turbines?

No, except concentrated solar thermal plants. Wind turbines and photovoltaic panels do not.

How big is the biggest steam turbine?

Arabelle Solutions says its Arabelle suits reactors from 700 to 1,900 MW, with a 75-inch last-stage blade.

Is coal still the largest source of electricity?

Yes. Ember reports coal at 34.4% of global electricity in 2024, ahead of gas at 22%.

Sources

All generation shares are from Ember, Global Electricity Review 2025 (2024 data). 43.4% is 34.4% + 9.0%, added here, and counts only coal and nuclear; it is not a measured steam-turbine share. Arabelle figures are manufacturer claims. Supercritical thresholds and the 64% combined-cycle figure are from a general reference page citing manufacturer charts.

More from this book

History · From the book The Steam Turbine: Heat, Spin, Current

Who invented the steam turbine? Parsons, de Laval and a toy from Roman Egypt

The steam turbine has an inventor for the modern machine and a very long list of earlier tinkerers.

Process · From the book The Steam Turbine: Heat, Spin, Current

How a steam turbine works: nozzles, blades, stages and a condenser

A steam turbine is a rotor with blades inside a casing.

History · From the book The Steam Turbine: Heat, Spin, Current

Turbinia: the ship that proved the steam turbine

Parsons already had working turbines, including at Forth Banks power station, but he still had to prove the marine application.

Supply chain · From the book The Steam Turbine: Heat, Spin, Current

Who makes steam turbines, and why heavy forgings have limited supply

A large monoblock steam-turbine rotor shaft is forged from one piece of steel.