Process · Materials · Paper and Forest Products
How paper is made: from tree to reel
Every sheet of paper you have ever touched began as a soup that was ninety-nine percent water. Making paper is the art of taking that water back out, fast, flat, and for miles at a stretch.
From the book Paper: Fibre, Web, WorldChapters 16, 17, 20, 21 and 24. Read the full book free as a PDF.
Paper starts in the wood yard. Logs arrive from the plantation or the managed forest, are debarked in a rotating drum, and chipped into pieces the size of a large coin. From here the chips face one of two fates, and the choice decides what the paper will be.
Two ways to a pulp
Mechanical pulping grinds the wood apart, keeping everything: cellulose, lignin, resins, all of it. The yield is high, and the pulp is cheap and bulky, but the lignin it keeps turns the paper yellow and brittle in sunlight. This is newsprint's pulp. Groundwood was first made in Germany in the early 1840s, though it took until about 1870 to come into wide use.
Chemical pulping cooks the chips in liquor that dissolves the lignin and frees the cellulose fibres. The yield is lower, but the fibre is long, strong and clean, and it can be bleached white (kraft pulp is dark before bleaching). The dominant recipe is the kraft, or sulfate, process, developed by Carl F. Dahl of Danzig in 1879 and patented in 1884, and prized because its chemicals are recovered and burned for the mill's own power. This is the pulp of office paper, books and box liner.

The wet end
Pulp, however made, is washed, screened and beaten to fray the fibres so they will lock together. Then it meets the machine. It is diluted to a thin slurry, mostly water, and sprayed from the headbox onto the wire, an endless moving mesh belt. Water falls through the mesh, the fibres settle into a mat, and within seconds a fragile wet web exists where there was only soup. That web is the sheet; everything after is about drying it without hurting it.
Press, dry, finish
The web is carried off the wire and run through the press section, where heavy rollers squeeze out water that gravity could not. Then come the dryers, dozens of steam-heated cylinders that evaporate the rest. A size press may add a starch film for stiffness and printability, and the calender, a stack of polished steel rolls, irons the surface to its final smoothness. At the dry end the finished paper winds onto the reel in a single continuous ribbon, metres wide and kilometres long, ready to be cut into the sheets and rolls the world actually buys.
The other half of the log
Nothing at a kraft mill is thrown away. The spent cooking liquor, loaded with the dissolved half of the wood, is concentrated and burned in the recovery boiler, which regenerates the cooking chemicals and supplies much of the mill's steam and power. The bark fires the hog-fuel boiler. A modern pulp and paper mill is closer to a refinery than a factory: wood goes in, and paper, power and chemistry come out.
Read the full story of the fibre, the machine and the grades in Paper: Fibre, Web, World, a free Industries of India book.
Quick answers
How is paper made?
Wood is debarked and chipped, turned into pulp by grinding or chemical cooking, diluted to a thin slurry, formed on a moving wire, pressed, dried on steam-heated cylinders and wound into reels.
What is the difference between mechanical and chemical pulp?
Mechanical pulping grinds the wood and keeps the lignin, so it gives a high yield and cheap paper that yellows. Chemical pulping dissolves the lignin and leaves cellulose-rich fibres that can be bleached white.
