Cover of The Transistor, a book by Ketineni RamaraoFrom the book The Transistor
Chapters 7 and 28. Read the full book free as a PDF.

Three layers, two junctions

A bipolar junction transistor is a three-layer sandwich with two p-n junctions. The outer layers are the emitter and the collector, and the thin middle layer is the base. In an NPN transistor the emitter and collector are n-type and the base is p-type. A PNP transistor swaps every letter.

Two side-by-side diagrams of three-layer transistors. NPN: n-type emitter, thin p-type base, n-type collector, with electrons as the main carriers. PNP: p-type emitter, thin n-type base, p-type collector, with holes as the main carriers.
NPN and PNP bipolar transistors. Original IOI diagram.

How an NPN transistor works

In forward-active operation the base-emitter junction is forward biased and the collector-base junction is reverse biased. The forward bias pushes electrons from the n-type emitter into the base. The base is thin and only lightly doped, so there are few holes there to absorb the electrons. Most electrons cross it and are swept into the collector by the reverse-biased junction. Only a small fraction recombine in the base, and the base current that supports this is small. That small base current controls the much larger collector current.

How a PNP transistor works

It works the same way with the roles reversed. The emitter is p-type and injects holes into an n-type base. Most holes cross the thin base to the collector, and the supply voltages are reversed to match: the emitter is positive with respect to the base, and the collector is negative. The main carriers in an NPN are electrons and in a PNP they are holes. In both, the majority carriers flow from emitter to collector.

Why both are called bipolar

Although one carrier type dominates in each device, both electrons and holes are involved in the current flow, because the carriers that cross the base are minority carriers there. That is why these devices are called bipolar junction transistors. Field-effect transistors, by contrast, are called unipolar because they use one type of carrier. See the FET transistor explained.

The side-by-side comparison

Where each came from

The first practical junction transistors were NPN. In 1951 Gordon Teal and Morgan Sparks made an n-p-n grown-junction transistor at Bell Labs from a large single crystal of germanium. The first commercial silicon transistor, from Texas Instruments in 1954, was also an n-p-n grown-junction device. William Shockley had conceived the three-layer junction transistor in January 1948, built on the p-n junction Russell Ohl found in 1940, and the theory of holes crossing a base is his. The story is in the history of the transistor.

The pair that still matters

The idea of two opposite types lives on in chips. In 1963 Frank Wanlass and C. T. Sah showed at Fairchild that logic built from complementary p-channel and n-channel MOS transistors drew close to zero power on standby. That is CMOS, and it is the dominant way chips are built today. The devices are field-effect rather than bipolar, but the pairing of opposite types is the same insight.

Quick answers

What is the main difference between NPN and PNP?

NPN has an n-p-n layer order and electrons carry the main current. PNP has a p-n-p order and holes carry it. The supply voltages have opposite polarity.

Do NPN and PNP do the same thing?

Yes. In both a small base current controls a much larger current from emitter to collector, so each can switch or amplify.

Why is the base so thin?

So that most carriers from the emitter reach the collector instead of recombining in the base. A thin, lightly doped base is what lets a small base current control a large collector current.

Go deeper in the book: The Transistor · PDF · Source Companion · Browse the category

Sources

Operation, bias and carrier descriptions are from the three educational sources listed. The history of the first NPN devices is from the Computer History Museum. The comparison follows Chapters 7 and 28 of the book.

More from this book

History · From the book The Transistor

The history of the transistor

The transistor was not found by luck.

Explainer · From the book The Transistor

How transistors work

A transistor lets a small electrical signal control a much larger flow of current.

Explainer · From the book The Transistor

The FET transistor and the MOSFET, explained

The field-effect transistor was patented in the 1920s and could not be built for another thirty years.

Power · From the book The Transistor

What is an insulated gate bipolar transistor (IGBT)?

Logic transistors switch at very low voltages.